ioLogik E2262

Active Ethernet I/O with 8 thermocouple inputs and 4 digital outputs

	Datasheet Manual Drivers & Software
Larger image

Features

Specifications

Ordering Information

Features and Benefits

Supports J, K, T, E, R, S, B, and N type thermocouple and mV modes
Conversion Time: Less than 90 ms
Instant event messaging by TCP/UDP/email/SNMP-Trap
PC-based configuration utility and web console
Easy-to-use Click&Go™ Logic for local output control
Windows/WinCE VB/VC.NET and Linux C APIs
I/O control over Modbus/TCP and SNMP protocol
NIST traceable calibration

Introduction

Extend the Wiring Length

The ioLogik E2262 can extend the wiring length of your sensors up to 10 fold. For example, whereas the wiring for a J-Type may normally extend only 10 m, the ioLogik E2262 can be used to increase the J-Type TC wiring length up to 100 m.

More Accurate Temperates

The ioLogik E2262 has two cold junction compensation sets and supports digital filtering. Calibration, linearization, and calculation are based on the devices traced by the NIST (National Institute of Standards and Technology), and are stored in memory to eliminate this source of error. The ioLogik E2262 can also detect burnout and disconnection.

More info >>

• LAN:
Ethernet	1 x 10/100 Mbps, RJ45
Protection	1.5 KV magnetic isolation
Protocols	Modbus/TCP, TCP/IP, UDP, DHCP, Bootp, SNMP (MIB for I/O and Network), HTTP, CGI, SNTP

• Serial:
Interface	RS-485-2w: Data+, Data-, GND
Serial Line Protection	15 KV ESD for all signals

• Serial Communication Parameters:
Baudrate	1200 to 115200 bps
Data Bits	8
Stop Bits	1
Parity Bit	None
Flow Control	None
Protocols	Modbus/RTU

• Thermocouple Input
Channels	8
Effective Resolution	16 bits
Accuracy	±0.1% FSR @ 25°C ±0.3% FSR @ -10 and 60°C
Input Impedence	1 M ohm or better
Sensor Type	J, K, T, E, R, S, B, N type TC and mV mode
Conversion Time	Less than 90 ms

• Digital Output:
Channels	4, sink type, 36 VDC, 200 mA
I/O Mode	DO or Pulse Output (up to 100 Hz)
Pulse Wave Width/Frequency	10 ms/100 Hz
Over-voltage Protection	45 VDC
Over-current Limit	750 mA
Over-temperature Shutdown	175°C
Isolation	3K VDC or 2K Vrms

• Physical Characteristics:
Wiring	I/O cable max. 14AWG

• Environmental Limits:
Operating Temperature	-10 to 60°C (14 to 140°F)
Storage Temperature	-40 to 85°C (-40 to 185°F)
Ambient Relative Humidity	5 to 95% (non-condensing)

• Power Requirements:
Power Consumption	282 mA typical @ 24 VDC
Power Input	24 VDC nominal, 12 to 48 VDC

• Agency Approvals:
EMI	FCC Part 15, CISPR (EN55022) class A
EMS	IEC 61000-4, IEC 61000-6
Shock	IEC 60068-2-27
Freefall	IEC 60068-2-32
Vibration	IEC 60068-2-6